What Is The Easiest Way To Remove Carpet Staples

If needed cut the carpet into manageable pieces with a razor knife and roll them into tubes before placing them into the trash can.

What is the easiest way to remove carpet staples. The best way to remove the carpet pad is to fold it up. Cut the pad into strips and roll it up just as you did with the carpet. The best tool for removing carpet staples is a heavy duty office stapler. On a concrete floor the carpet pad is often glued into place.

Instead they ve developed a smart efficient way to remove staples with a shovel or long handled floor scraper. Tough spots might require a power oscillating tool. How do i avoid damaging the finish on the hardwood. Use pliers to pull each staple from the subfloor image 2 then place staples into disposable plastic cup.

One way to do this is to lift the carpet away from the floor as you cut. It also shows how to remove carpet pad staples easy https. Our were on the treads and the risers. Tear out the padding under the carpet.

The most time consuming step in the process is removing staples. The very flat tip of the heavy duty office stapler will slide under carpet staples easily. Use a hammer to pull out stray tack strip nails or hammer in any nails that aren t flush. Stray staples and nails will be scattered throughout the material so continue wearing gloves.

Use a crow bar to remove the tack strips. It s usually laid in smaller sections and it s stapled along its edges. However a set of pliers flathead screwdriver and a 6 in 1 painter s tool are helpful to have on hand too. How to dispose old carpet.

Removing the carpet tacks and staples. Ours seemed to be stapled by someone very determined and very drunk lots and lots of staples all over the place. To remove them use a floor scraper. Flooring installers don t use a cat s paw to remove staples after old carpet has been removed there are just too many of them.

On a concrete floor the pad is glued in place so big chunks of pad will remain stuck to the floor. Hold the tool at about a 45 degree angle and slide it forcefully along the floor. If you are trying to salvage the floor underneath make sure you do not cut grooves in the floor with the knife. Use a utility knife or carpet knife to slice the carpet into manageable strips and roll the strips up as you go.

With a motion similar to using a push broom go around the entire room to slice off or yank out the staples with the scraper. When you ve torn off all the carpet and pad pull out all the staples with pliers. In this case use a floor scraper to remove the pieces of padding that remain stuck to the floor. Throw them away as you remove them to avoid accidentally stepping on them.